TECHNICAL INFORMATION
To confirm the choice press
SET
key. If no serial
module are mounted on the controller the display
return to the previous message:
Or:
T S P
F i l a m e n t X
v
M A N
M i n i
T i - b a l l
v
M A N
Where X can be 1, 2 or 3 depending on the TSP
filament selected. The message
MAN
that appears
at the end of the second row indicates the operation
mode currently set (factory set MANUAL).
Or:
T S P F i
l a m e n t X
v
M A N
To enable the configuration mode to modify the
autostart and the automatic change of the TSP
filament press the
MODE
and
SET
keys.
Otherwise, if serial module are present on the
controller the display shows:
NOTE
Before activating the configuration mode, make
sure that the SUBLIMATION Led is off.
S E R I A L A D D R E S S
v
X X X
The display shows:
S U B L I M A T I O N
v
A U T O S T A R T : Y E S
Where
XXX
is the serial address currently set, then
the display shows;
S E R I A L B A U D R A T E
v
X X X X B A U D
The AUTOSTART is factory set on YES. This
enable the automatic restart of the sublimation after
a shut down. Press
V
or
W
key to change from
YES to NO and viceversa. The display shows:
Where
XXXX
is the speed of communication
expressed in Baud.
S U B L I M A T I O N
v
A U T O S T A R T : N O
NOTE
If the RS 232 Computer Interface Card is mounted
on the controller, the message “SERIAL ADDRESS
XXX” is not displayed.
Make the selection then press
SET
key to confirm
the choice.
If a cartridge with multiple TSP is present the
display will show:
Operating Mode Selection
T S P R E C O V E R :
v
A
U
T
O
M
A T I C
The operating mode selection permits the selection
of the mode by means of which the Sublimation
Controller is controlled.
To select the operating mode press the
MODE
key.
Factory setting is AUTOMATIC, that enables the
automatic change of the TSP filament in case of
fault (if possible). This configuration can be
changed on MANUAL by pressing the
V
or
W
key.
In this case the display shows:
The display shows:
M O D E :
v
M A N U A L
T S P R E C O V E R :
v
M
A
N
U A
L
In this operating mode the selection of time, period
and current value of sublimation are set by means
of the control panel.
In MANUAL configuration, in case of interruption of
the TSP filament, the controller will be in a fault
condition and the sublimation will be interrupted.
20 87-900-077-01(D)
Summary of Contents for 929-0022
Page 2: ...Sublimation Controller ...
Page 3: ......
Page 4: ......
