Agilent Technologies 86121A, User Manual, Page: 142 / 240

CALCulate2 Subsystem 5
-
27
Attribute Summary
Non-sequential command
Preset State: 236.0571 THz
*RST State: 236.0571 THz
SCPI Compliance: instrument specific
Description
This command sets the stopping range for the wave-
length limit. The default units for the <
real > parameter
are Hz. The stop frequency value must be greater than
or equal to the start frequency value or the stop fre-
quency will be clipped to the start frequency and a
“Data out of range” error will be generated.
:CALCulate2:WLIMit:STOP[:WAVelength] {?|{<real> | MINimum | MAXimum }}
Sets the stopping wavelength for the wavelength limit
range.
< real > is a wavelength value that is within the following
limits:
Attribute Summary
Non-sequential command
Preset
State: 1650 nm
*RST State: 1650 nm
SCPI Compliance: instrument specific
Constant Description
MINimum start wavelength limit
MAXimum 236.0571 THz (1270 nm)
Non-sequential command
Always use an *OPC? query or a *WAI command to ensure that
this command has the time to complete before sending any
more commands to the instrument.
Refer to “Always force the
Agilent 86121A to wait for non-sequential commands” on
page 4-11
for more information.
Constant Description
MINimum start wavelength limit
MAXimum 1650.0 nm