Agilent Technologies 86121A, User Manual, Page: 140 / 240

CALCulate2 Subsystem 5
-
25
Whenever the 86121A receives this command, it repro-
cesses the data and performs a new peak search.
:CALCulate2:WLIMit:STARt:FREQuency {?|{<real> | MINimum | MAXimum }}
Sets the start frequency for the wavelength limit range.
< real > is a frequency value that is within the following
limits:
Attribute Summary
Non-sequential command
Preset
State: 181.6924 THz
*RST State: 181.6924 THz
SCPI Compliance: instrument specific
Description
This command sets the starting range for the wave-
length limit in hertz. The start frequency value must be
less than or equal to the stop frequency value or the
start frequency will be clipped to the stop frequency
and a
“Data out of range” error will be generated. The
default units for the < real > parameter are hertz.
Non-sequential command
Always use an *OPC? query or a *WAI command to ensure that
this command has the time to complete before sending any
more commands to the instrument.
Refer to “Always force the
Agilent 86121A to wait for non-sequential commands” on
page 4-11
for more information.
Constant Description
MINimum 181.6924 THz (1650 nm)
MAXimum wavelength limit stop value
Non-sequential command
Always use an *OPC? query or a *WAI command to ensure that
this command has the time to complete before sending any
more commands to the instrument.
Refer to “Always force the
Agilent 86121A to wait for non-sequential commands” on
page 4-11
for more information.