Agilent Technologies 81250, Installation Manual

Page: 99 / 146

Installing the Trigger Input Pod 6 Changing the ParBERT Hardware
Agilent 81250 ParBERT Installation Guide, May 2004 6-21
4 Plug the trigger input pod into the appropriate 16-pin socket on the
clock board, as shown in the following figure.
Socket for trigger
input pod
Figure 61 Clock Module Connector for the Trigger Input Pod
5 Close the clock module.
6 Re-install the clock module in the mainframe as described in
“Installing a Module” on page 6-4 .
Contact the Agilent support if you need additional probe leads for the
trigger pod. The required part number is 16520-62102. You need to
remove the leads from the probe adapter header before plugging them
into the pod housing.