Agilent Technologies 53150A, Service Manual

Page: 69 / 111

Chapter 3 Replacing Assemblies
Removing the Bumpers
3-4 Assembly Level Service Guide
3
Removing the Bumpers
Use the following procedure to remove the front and rear bumpers:
1 To remove the front bumper, lift the center of the top of the bumper
upward, stretch a corner of the bumper diagonally, then slide it off the
front of the Counter.
Figure 3-1. Removing the Bumpers
2 Use the equivalent procedure for the rear bumper.
NOTE The bumpers can be used to support and protect the Counter after the
shroud is removed. Place both bumpers on their inner edges on your work
surface, and then place the Counter on top of them. The rear bumper can
also serve as a holder for screws and other hardware temporarily removed
from the Counter.
OPTIONS