46 Operation
4510012 - REV F – 220621
Adjusting Manifold Angle
If desired, the Steam Jets of each Manifold can be angled upward or downward to further
customize how steam is directed.
To Adjust the Angle of the Manifolds:
If not already done, power off the GEN-S and allow the system to cool to 100 °F.
Once the system has cooled, continue to be cautious of heat and steam.
Open all four Manifold Access Doors.
To redirect the angle of the Steam Jets on a Manifold, use a 13 mm Wrench to
loosen the Cap Screws on the Manifold Cuffs on both ends of the desired Manifold
(just inside each opening of the Steam Tunnel).
Rotate the Manifold so that the holes along its length are directed at the desired
angle for steam output.
Use the 13mm Wrench to retighten the Cap Screws when finished
Repeat for any other Manifolds for which a change in Steam Jet angle is desired.
Manifold
Cuffs
Steam
Manifolds
Cap
Screws
AFM-4510012-00050-01
AFM-4510012-00068-01
Rotating the Steam Manifolds
Steam Manifold
(Cross Section)
Steam
Jet
Summary of Contents for STC-WSN300-2M
