Installation and Setup 33
4510012 - REV F – 220621
Plumbing and Valve Connections
The GEN-S requires a connection to a consistent source of filtered or softened water.
ATTENTION:
Only clean filtered or softened water should be used. Failure to do so
will result in shortened Boiler life
and cause an increase in sediment buildup, which
will negatively impact performance.
Needed to Make Plumbing and Valve Connections:
•
Licensed Plumber who works in accordance with all applicable national and local
plumbing codes
•
Water Line that supplies filtered or softened water
•
Drainage Lines
To Make Plumbing and Valve Connections:
Install a connection from the filtered or softened water source to the Water Inlet on the
upstream end of the unit. The valve on the Water Inlet will need to remain in an open
position during normal operation.
Connecting to the Water Inlet
Water
Inlet
Summary of Contents for STC-WSN300-2M
