WING ASSEMBLY
9
1. Gather the aileron servos and control horn parts
as shown below.
2. The Stingray comes with CA style hinges pre
installed, but not glued into the control surfaces.
Hinge ailerons by first pushing a T pin through
the center of all CA hinges. This will ensure
hinges remain centered. Next, slide hinges into
pre-cut slots. Make sure that slot in CA hinge
runs perpendicular to hinge line. This allows CA
to wick to the back of the hinges.
3. Next slide the aileron onto wing making sure all
hinges go into their slot. Remove the T pins and
press the aileron against the wing trailing edge.
Allow enough hinge gap to ensure maximum
control throws.
4. Next, place 3-4 drops of thin CA on each side of
all hinges. Do not over soak the CA hinges.
Glue may run out and cause binding.
