29. Slide the left elevator onto the wire elevator
connecting rod and the CA hinges. Wipe away
any excess epoxy with alcohol wipes. Ensure
there is no epoxy remaining anywhere between
the trailing edge of the stab and the elevator.
30. Slide the right elevator onto the wire elevator
connecting rod and the CA hinges. Wipe away
any excess epoxy with alcohol wipes. Ensure
there is no epoxy remaining anywhere between
the trailing edge of the stab and the elevator.
31. Slide the elevators onto the stab making sure all
hinges go into their slot. Remove the T pins and
press the elevator against the stab trailing edge.
Allow enough hinge gap to ensure maximum
control throws. Place 3-4 drops of thin CA on
each side of all hinges. Do not over soak the CA
hinges. Glue may run out and cause binding
32. Make a 90º bend 1/4” from the end of the wire
elevator pushrod.
24
