33. Slide the nylon pushrod keeper onto the elevator
pushrod as shown below.
34. To help with alignment, tape the leading edge of
the elevator to the stab as shown. First slide the
push rod through the servo arm easy link and
then install pushrod through the middle hole in
the control horn. Install the nylon pushrod
keeper onto the end of the pushrod as shown.
Ensure the servo arm is centered in the neutral
position and then tighten the easy link screw
against the wire pushrod.
35. Use wire cutters to cut off the excess elevator
pushrod wire. Leave approximately 1/4 to 3/8”
extended out of the easy link for any future
adjustments.
25
The stab and elevator installation is now complete.
