Installation and Configuration
Npaq® Hardware Manual
2.10. Analog I/O Connector (J10)
The Analog I/O Connector (J10) is a 15-pin ‘D’ style connector located on the Rear Panel Interface board and
is accessible at the rear of the Npaq chassis. The Analog I/O interface provides the user with four differential
16-bit analog inputs and two single-ended 16-bit analog outputs.
provides the specifications for
the analog outputs.
Table 2-39:
Analog I/O Connector Pinout (J10)
Pin #
Description
In/Out/Bi
Connector
1
Analog Input 0+
Input
2
Analog Input 1+
Input
3
Analog Input 2+
Input
4
Analog Input 3+
Input
5*
+5 Volts
Output
6
Analog Output 0
Output
7
Analog Ground
N/A
8
Analog Ground
N/A
9
Analog Input 0-
Input
10
Analog Input 1-
Input
11
Analog Input 2-
Input
12
Analog Input 3-
Input
13
Not Used
N/A
14
Analog Output 1
Output
15
Analog Ground
N/A
* Pin 5 is unused on Npaq's produced before February 2009.
Table 2-40:
Mating Connector Part Numbers for the Analog I/O Connector (J10)
Mating Connector
Aerotech P/N
Third Party P/N
15-Pin D-Connector
ECK00100
Amphenol DA15P064TXLF
Backshell
ECK01022
Amphenol 17E-1725-2
N O T E :
Analog inputs 2 and 3 are required for Joystick operation. They will not be otherwise accessible if
a joystick option is present (see
). If a joystick option is present, AIN2 and AIN3 must be
jumper configured (see
) as single ended inputs.
www.aerotech.com
Chapter 2
75
