AERO-LIFT FORCE-LIFT, Instruction Manual

Page: 21 / 51

LIST OF CONTENS
FORCE-LIFT
®
21/51
4 Handling and operation
Transporting the product with the vacuum tube lifter
WARNING!
Danger due to loads falling
Incorrect pick-up and/or premature release of loads before they are fully resting can
cause severe injuries due to possible crushing, shearing or impact. Danger due to loads
falling!
✓
When operating the vacuum lifter, exercise caution!
✓
Pick up load only in center.
✓
Only release load when it is fully resting.
✓
After changing the suction plates/bases, check whether the connection has
been inserted correctly.
✓
Persons may NOT stay in the transport area.
✓
Always wear personal protective equipment when working on or with the device!
NOTE
Aligning the vacuum lifter
Lift tube and control head are mounted so that they can rotate. This means that the vacuum lifter can be
rotated to the desired position. If the vacuum lifter is to be mounted on a pillar-mounted slewing crane, it
is necessary to observe its working radius and reach.
NOTE
Daily functional check
Check the lift tube and the entire system for any damage every day prior to starting work!
Requirements
The vacuum lifter is mounted, a suitable suction foot is attached and adapted using the
regulating screw to the material of the product to be transported (3)
Vacuum pump or blower connected to the mains and switched on
The vacuum lifter can be raised or lowered by pressing the release button (2) and button (4)
together.