AERO-LIFT FORCE-LIFT, Instruction Manual

Page: 31 / 51

LIST OF CONTENS
FORCE-LIFT
®
31/51
Replace lift tube
Requirements
Vacuum lifter switched off
Loosen fastening clamp (2) at the bottom and put down the control head (3).
(1) Lift tube
(2) Fastening clamp
(3) Control head
Remove spiral wire from the lift tube (1) at the cup with the ball bearing on top (suspension).
Put down the old lift tube (1).
Fasten the new lift tube to the cup with the ball bearing on top (suspension) in a positive-fit
manner. In this case, screw the wire spiral onto the groove. Make sure that the closure is
airtight!
Fasten the new lift tube to the control head (3) with the clamp (2). To do so, pull the lift tube
over the control head. Make sure that the closure is airtight!
→ Lift tube was replaced.
WARNUNG!
Moving parts!
Crushing of fingers / hands when moving or adjusting the position of the suction plates,
during mounting or operation may lead to injuries.
✓
Do NOT touch or reach between individual suction plates (double-rectangular
suction foot), quick-changing coupling and suction foot or between other
components!
✓
Carefully install the vacuum lifter.
✓
Always wear personal protective equipment when installing and making
adjustments!