6
21.05 - 6068956_00
NXP 0500 - 1650 2-PIPE SYSTEM / 4-PIPE SYSTEM
EN
ATTENTION
The unit comes fixed on a pallet.
Use forklifts for handling
800mm
800mm
800mm
1100mm
1000mm
The unit has to be installed in technical rooms, or rooms
which have at least a drain on the floor.
2. RECEIPT AND HANDLING
•
The machine is delivered from the factory wrapped in estincoil.
•
Before handling the unit, verify the lifting capacity of the machines used.
•
Handling must be performed by qualified, suitably equipped staff.
HANDLING THE MACHINE:
Whenever the machine must be lifted using belts, place protections between the belts
and the framework to prevent damage to the structure.
2.0.1. LIFTING REGULATIONS
1.
All panels must be tightly fixed before handling the unit;
2.
Before lifting, check the specific weight on the technical plate;
3.
Use all, and only, the lifting points indicated;
4.
Use ropes in compliance with Standards and of equal length;
5.
Use a spacer beam in compliance with Standards (not included);
6.
Handle the unit with care and without sudden movements
SELECTION AND PLACE OF INSTALLATION
The Units sent from the factory already inspected and only requires electric and hy-
draulic
connections in the place of installation.
Before beginning the installation process, decide with the customer where the unit is
to be installed, whilst paying attention to the following:
1.
The support surface must be capable of
supporting the unit
weight.
2.
The safety distances between the units and other appliances or structures must be
scrupulously respected.
3.
The unit must be installed by a qualified technician in compliance with national
laws in the country of destination.
4.
It is mandatory to envision the necessary technical spaces in order to allow
ROUTINE AND EXTRAORDINARY MAINTENANCE interventions.
5.
Remember that during operation, the chiller can cause vibrations;
therefore an-
ti-vibration mounts (ACCESSORIES) are recommended
, which are fixed to the base
according to the assembly layout.
6.
Fix the unit checking that it is level.
ATTENTION:
•
It is prohibited to stop under the unit during
lifting operations.
•
The units CANNOT be stacked.
•
The unit must be installed in order to make
possible the maintenance and / or repair.
LIFT THE UNIT
MINIMUM TECHNICAL