ADTRAN NetVanta 1748F Series, Hardware Installation Manual

Page: 39 / 42

ADTRAN 1748F Switch Switch Management
61700558F1-34B Copyright © 2016 ADTRAN, Inc. 39
The following table describes the pin assignments used in the RJ-45-to-DB-9 console cable.
Table 14. Console Cable Wiring
The console port’s configuration requirements are as follows:
• Default Baud rate.115200 bps
• Character Size.8 Characters
• Parity.None
• Stop bit.One
• Data bits.8
• Flow control.none
Figure 21. Console Port Connection
Follow these steps to connect to the Console port:
Switch’s 8-Pin Console Port Null Modem PC’s 9-Pin DTE Port
6 RXD (receive data) <------------------ 3 TDX (transmit data)
3 TDX (transmit data) ------------------> 2 RXD (receive data)
5 SGND (signal ground) -------------------- 5 SGND (signal ground)
Instructions for Connecting to the Console Port
Step Action
1 Attach the DB-9 end of the included RJ-45-to-DB-9 serial cable to a DB-9 COM port connector on
a management PC.
2 Attach the RJ-45 end of the serial cable to the Console port on the switch.
3 Configure the PC’s COM port required settings using VT-100 terminal emulator software (such as
HyperTerminal) running on the management PC.
4 Log in to the command-line interface (CLI) using default settings: User admin, Password null
(there is no default password).