ADTRAN NetVanta 1748F Series, Hardware Installation Manual

Page: 37 / 42

ADTRAN 1748F Switch Switch Management
61700558F1-34B Copyright © 2016 ADTRAN, Inc. 37
Table 12. System Status LEDs
Connecting to the Management Port
The 10/100/1000BASE-T port labeled Mgmt provides a dedicated management interface which is segregated
from the data traffic crossing the other ports. The Mgmt port will attempt to receive an IP address and default
gateway from a DHCP server. If no DHCP server is present, you must use the Console port. Refer to the quick
start guide shipped with the unit for connection instructions.
This port supports auto-negotiation, so the optimum transmission mode (half or full duplex) and data rate (10,
100, or 1000 Mbps) can be selected automatically, if this feature is also supported by the attached device.
Figure 19. Management Port
Table 13. RJ-45 Management Port Status LEDs
LED Color Indication
PSU1/PSU2 Off Unit is not receiving power.
Green (solid) Power supply is installed and operating normally.
Amber (solid) The power supply has detected a fault.
Diag (Diagnostic) Green (solid) The system diagnostic test has completed successfully.
Amber (solid) The system self-diagnostic test has detected a fault.
Fan Green (solid) Fans are operating normally.
Amber (solid) A fan failure has been detected.
Loc (Locater) Amber (flashing) Activated through remote software to assist
identification of the switch unit within a rack.
LED Color Indication
Link/Activity Off There is no valid link on the port.
Green (solid) Port has established a valid network connection
Green (flashing) There is activity on the port.
Speed Green (solid) There is a valid 10/100 Mbps link.
Amber (solid) There is a valid 1000 Mbps link.
Speed LED Link/Activity LED
RJ-45 Management Port