C N C 4 2 2 0 M a c hi ne Too l Op e ra t ion an d Te st
55
12.2.
Program verification
12.2.1
GRAPH PARAMETER SETTING
In MDI mode, press the setting key
to enter the graph interface, and press
or
key to enter graph parameter page, as shown below:
Press the
or
key to move the cursor and select desired options of graph
parameters.
For example, to set “Maximum X”, press the
/
key to move the cursor to parameter
“Maximum X” (actual size of the semifinished product is 135mm and the input value should be
higher than 135m; 150 is set here), type
,
,
in sequence and then press the
key to have the page below:
Graph parameters
Coordinates selection
Scaling
+
Graph center X (work piece coordinates) (mm)
Graph center Z (work piece coordinates) (mm)
Maximum X (mm)
Minimum X (mm)
Maximum Z (mm)
Minimum Z (mm)
X origin bias of graph (mm)
Z origin bias of graph (mm)
Data =
MDI mode
Graph parameters
Coordinates selection
Scaling
+
Graph center X (work piece coordinates) (mm)
Graph center Z (work piece coordinates) (mm)
Maximum X (mm)
Minimum X (mm)
Maximum Z (mm)
Minimum Z (mm)
X origin bias of graph (mm)
Z origin bias of graph (mm)
Data =
Manual mode