C N C 4 2 2 0 M a c hi ne Too l Op e ra t ion an d Te st
25
Fig. 4-1-1
4.2.
Increment selection
Press the
key to adjust the increment of single step: if the current increment is 0.01,
press the
key to change the increment to 0.1, and press it again to change the increment to 1. To
reduce the increment, press the
key.
4.3.
Motion direction selection
Press the
or
key once to feed once the axis X in single step increment in negative
or positive direction; press the
or
key once to feed once the axis Z in single step
increment in negative or positive direction.
4.4.
Handwheel feeding
Press the Single step
key to enter handwheel operation mode, which is shown in the figure
below:
See the description in
Section 1.1, and the
value
varies
according
to
the
selection
Current position (absolute coordinates)
Single step G code:
increment: Processing pieces:
Cutting time:
Single step mode