C N C 4 2 2 0 M a c hi ne Too l Op e ra t ion an d Te st
28
Note: Subroutine call instruction (M98 P___ ;) and composite cutting cycle instruction (G70, G71,
G72, G73, G74, G75, G76, etc.) are invalid in MDI.
5.2.
Parameter editing and setting
You can edit and set the parameters only in MDI mode.
6.
Program editing and management
In the editing mode, you can create, select, edit and delete programs. To prevent the
program from unexpected modification and deletion, the system integrates program switch.
Before editing the program, please turn on the program switch.
6.1.
Creating program
6.1.1
PROGRAM CONTENT INPUT
1) Press the Edit key
to enter the editing mode;
2) Press the Program
key to enter the program page, and press the
key to
select program editing interface if necessary.
3) Type the address key O and number key 0001 in sequence (to create program O0001).
4) Press the Insert key
to create new program, as shown in the figure:
Program
Data=
MDI mode