C N C 4 2 2 0 M a c hi ne Too l Op e ra t ion an d Te st
18
1.5.11
PARAMETER INTERFACE
Press the Parameter key
to enter the interface, which consists of system parameters and
data parameters. You can press the Up/Down key
to view. In parameters display page,
the prompt line of parameter contents displays the contents of the parameter that the cursor points
to. The parameters can be edited in MDI mode. Input the target parameter number and press the
EOB key to go to the specified parameters.
Parameter settings
1. Axis X instruction magnification
2. Axis X instruction frequency conversion coefficient
3. Axis Z instruction magnification
4. Axis Z instruction frequency conversion coefficient
5. Feeding speed
6. Start feeding speed
7. Feeding acceleration time
System parameters Page 1
1. Axis X instruction magnification
Manual mode
Fig. 1-3-15
1.5.12
DIAGNOSIS INTERFACE
The Diagnosis key
is composite, and you can press it repeatedly to switch between
diagnosis interface and machine tool panel interface.
Diagnosis interface display
Press the Up/Down key
to view the I/O signal state and system state of the
diagnosis display system and machine tool
Input point status interface
Input point state
(mm/min)
(mm/min)
(mm/min)