OPERATING AND USER MANUAL OPAL FAMILY
60
IMAGE AND DATA FORMATTING
Output LookUp Table end.
8.13.3.
After filling the output look-up table with 4096 vales, the table should be closed. This is done through
the OLUTEND command.
Command syntax: OLUTEND
NOTE:
If the camera did not receive exactly 4096 entries, the LUT definition is ended, but LUT data is
not saved to non-volatile memory. The previous LUT is restored (if no valid LUT was found, a unity LUT
function is used instead) and error result is set to 122.
Output LookUp Table enable.
8.13.4.
The user look-up table can be enabled or disabled by means of the OLUTE command.
Command syntax: OLUTEx
Where x is set to 1 for enabling the LUT and 0 to disable the LUT.
The actual setting can be read back from the camera.
Summary of Contents for Camera Link OPAL Series
