Adicos GSME-M4, Operating Manual

Page: 34 / 44

MAInTEnAnCE
32
ADICOS GSME 405-2010-003 EN52
8 Maintenance
The following maintenance measures must be performed in the specified cycle.
Measure
Cycle
daily quarterly yearly
Check for fault message via BMZ and/or software
(–› Chap. 9, Fault)

Visual inspection for condensation on the detector enclosure
(–› Chap. , Condensation and contamination)

*
Visual inspection for damage on detector,
attachment and connection cable

Visual inspection for incrustation of the sintered metal filter
(–› Chap. 8.1, Condensation and contamination)

Function test of the “Alarm” and “Fault” signal relays
(–› Chap. 8.3, Function test of the signal relays)

Measurement of the supply voltage in the connection boxes
(Permissible voltage range 21,6 ... 40 V)

Function test with ADICOS GTL-3 GSME tester
(–› Chap. 8.4, Annual function test)

* Within the first three months after commissioning
8.1 Condensation and contamination
Condensation on the detector enclosure, in particular in the area of the sintered metal filter,
can lead to reduced sensitivity of the ADICOS GSME detector. If damp dusts form deposits on
the detector, the sintered metal filter can become encrusted, which leads to reduced detec -
tivity or even ineffectiveness of the detector.
For this reason, condensation must be avoided under any circumstances. In the case of con -
densation, switch on detector heating and use spray protection! In addition, the sintered metal
filter must be checked for incrustation within the scope of quarterly maintenance as well as
regularly within the first three months after commissioning.
8.2 Cleaning
In the normal case, the ADICOS GSME also works with heavy contamination. Dry dust can be
removed using a vacuum cleaner as needed.
The sintered metal filter can clog when coming in contact with water and dirt.
• Clean the sintered metal filter dry only!