adept technology GadgetGateway, User Manual

Page: 58 / 124

4.4 709.1/IP Gateway Setup Menu
4-12
GadgetGateway Serial Interface
Make your selection and press ENTER. The new node type will appear in the menu.
4.4.8 Set Gateway IP Port
When 852 bridge mode is enabled there are two 852 interfaces, one for each of the
bridged channels, that is, far side and near side. Each interface shares one IP host address
but each interface must have a unique IP port number. To set the far side port when in 852
bridge mode or to set the single port when not in bridge mode:
Select [I] from the menu and press ENTER.
NOTE: Requires Restart to take effect.
Enter Your New IP Port:
Input the Gateway's communication port (0-65534) and press ENTER. The new port will
appear in the menu. (The default is 1628.). If you press ENTER without typing in any-
thing the previous value is retained.
To set the near side IP port when in bridge mode:
Select [X] from the menu and press ENTER.
NOTE: Requires Restart to take effect.
Enter Your New IP Port:
Input the Gateway's near side communication port (0-65534) and press ENTER. The new
port will appear in the menu. (The default is 1630.). If you press ENTER without typing in
anything the previous value is retained.
4.4.9 Set NAT Router WAN Address
Select [W] from the menu and press ENTER.
>>> w
GG
Router
GG
Router
Channel 1 (709.1) Channel 2 (709.1)
Transparent Channel 3 (IP)
Network Tool
Virtual
GG
Router
FIGURE 4.2 Channel Configuration in Paired Virtual Router mode.