adept technology GadgetGateway, User Manual

Page: 113 / 124

6-3
GadgetGateway Firmware Upgrade 6.1Firmware Upgrade Instructions
HARDWARE PARAMETERS:
Serial channels will use a baud rate of 9600
This board's MAC Address is 61:61:61:61:61:61
After board is reset, start-up code will wait 5 seconds
-----------------------------------------------------------------------------
Press any key in 5 seconds to change these settings.
MaxSector size = [60]
RAM based FTP Server ready.
The FTP server application that allows the updated firmware to be downloaded to the node
is now running on the GadgetGateway.
The previous prompt is for the bootloader. It provides similar functionality to the Gadget-
Gateway IP setup prompt described in Section 4.2 however they are distinct programs and
each has its own IP setup parameters. If the IP address displayed by the bootloader is not
the same as the IP address of the gateway then this prompt provides the opportunity to
change the bootloader’s IP address. Just hit any key within 5 seconds. and the following
prompts will be displayed.
Press A to Accept the settings, or M to Modify [M]?m
Enter the root password: ******
For each of the following questions, you can press <Return>
to select the value
shown in braces, or you can enter a new value.
NETWORK INTERFACE PARAMETERS:
Should this target use DHCP to get its IP settings?[N]n
IP address[10.0.2.95]?
Subnet mask[255.255.255.0]?
Gateway address[10.0.2.254]?
SECURITY PARAMETERS:
Would you like to update the root password?[N]
HARDWARE PARAMETERS:
How long (in seconds) should CPU delay before starting
up[5]?
Saving the changes in NV memory...Done.