Additel ADT286, User Manual

Page: 118 / 129

117
3. Add Temperature Source
4. Test Process
After the temperature is stable, click for the reading, then change the measurement position of the two
sensors, read it again after stabilization, repeat the above steps until four readings are made and finally find
temperature difference value among holes according to the formula. Click to view the temperature
difference value, click to save the data.
4.4.3 Axial uniformity temperature test
Test the uniformity of the axial temperature distribution in the measurement block of a dry well or furnace
1. Test Settings

Channel selection: select the channels to be tested.

Function: select the corresponding sensor type.

Wire system: select the corresponding sensor wire system.

Compensation internal: set the compensation interval of corresponding sensor (in ms).