ADB EURODIM TWIN TECH, Installation Manual

Page: 89 / 166

www.adblighting.com Quick Start - page 23
Issue 1.0
10. Description of the Menus
Two screen pages are available in order to choose a function, enabling the cabinet to be
configured using one of the following menus:

Patch: to edit patch A or B for each circuit

Laws/Mult.F: to choose the law used and the multiplying factor for each of the
circuits

Conf. Power: to assign the modules used and detected in the 32 cabinet locations

Cues/DMX fail: cue management and action to be performed after a absence of
DMX/ARTNET

View all: overall view of all the parameters per module or per circuit

Test/Flash: to launch a test or the flash of a circuit

Load/Save: to save and load the parameters of the controllers and of each circuit

Settings: Human-Machine interface configuration

Scan loads: to measure/scan the loads connected at the outputs of each circuit

Mod. Meas.: gives the voltage and current measurements for each circuit

Mod. Diag.: gives the diagnosis of the outputs of each module

ARTNET patch: to edit the patch of the three ARTNET universes for each circuit

View ARTNET: general information on the ARTNET universes and the Ethernet
connection

ARTNET set.: to configure the three ARTNET universes

ADB Service: function available to ADB technical service only

Synchro: to synchronise the parameters recorded between each of the controllers