ADB EURODIM TWIN TECH, Installation Manual

Page: 158 / 166

EURODIM TWIN TECH
www.adblighting.com User Manual - Page 56
Issue 1.1

"last value": the last values received to control the circuits are used permanently as
long as the universe is missing,

"cue" 0: the values of the universe channels are replaced by the content of cue 0 and
will be played as long as the universe is missing,

"black": the control value of each circuit fades to zero intensity (black) in 5 seconds.

When the universe is present once more, a fade is launched to the intensities given by
ARTNET in a time of 5 seconds.
When the universe is present once more, a fade is launched to the intensities given by ARTNET in
a time of 5 seconds.

start addr.: value of the universe channel to address cabinet output 1, see "ARTNET
PATCH" menu

"x": 1 ≤ x ≤ 512

"not used": channel value = 0 or > 512

"- - - - -": no circuit physically present in cabinet location 1, or circuit identification error
in cabinet location 1 or operating fault.

Patch: see "ARTNET PATCH" menu,

Yes: the addressing entered in each patch at the circuits is not in ascending order,

No: the addressing entered in each patch at the circuits is in ascending order, e.g. 1, 2,
3, 4,…., 128 in the case where 32 modules are present in the cabinet.

Subnet: value between 0 and 15, see "ARTNET config" menu

Port: value between 0 and 15, see "ARTNET config" menu
Note : When the ARTNET entries are controlled by an ISIS rotating ADB console, all the subnets
must have the same number.
Ethernet Information
The IP address of each controller and the value of the sub-network mask are given.
Important : the IP addresses of each controller must be different. If this is not the case, it is
imperative to address the ADB technical department.
37. ARTNET Configuration Menu
This function configures the ARTNET universes for the two controllers as well as the subnet and
port values.