ADB EURODIM TWIN TECH, Installation Manual

Page: 151 / 166

EURODIM TWIN TECH
www.adblighting.com User Manual - Page 49
Issue 1.1
Information displayed according to the module type:
circuit technology Sinewave, thyristor, fluo with or without diagnosis
input V voltage measured at the module input (identical information for the four
circuits); Voltage in V
output V Voltage measured at the output of each circuit; Sinewave module: always N/A
output I Output current per circuit.
Sinewave and Thyristor modules with Diag: measurement (A) accurate to one
decimal point
Controller vers. Module software version
Controller sec. vers. Indication available only for sinewave modules
33.1 Selecting the modules and circuits
To select a module or circuit, position on the module or dimmer number (highlighted), either by
touching the screen or using the wheel.
To display the module or circuit measurements:

Touch the zone of the number or use the wheel,

Type the number using the keyboard,

Validate the number by touching the screen to select the zone in question, or using the
wheel.
Otherwise, press keyboard key 1 to scan the modules (circuits) in ascending order, or press
keyboard key 0 to scan the modules (circuits) in descending order.
34. Modules Diagnosis Menu
This menu is used to verify the operation of the modules and obtain detailed information on the
operation of each circuit. It is useful in the event that an error is detected and displayed in the
diagnostic screen page.