ADB EURODIM TWIN TECH, Installation Manual

Page: 111 / 166

EURODIM TWIN TECH
www.adblighting.com User Manual - Page 9
Issue 1.1
8.1 Synchronization
The human interface is synchronized continuously between two controllers (if present).
If two controllers are present, data from a controller (the one inserted into the slot from the top),
with the exception of the page "Diagnosis of the cabinet" or information from the selected controller
using the tabs "CTRL1" and "CTRL2".
If the controller 1 is a not functional, timing continues with the controller 2.
If the cabinet has only one controller all the information obtained from this controller
Note: Only the controller in slot from the top is able to detect modules in the cabinet (see Chapter
Power Configuration) and to report the status of sinewave and thyristor modules with full
diagnostic option (see section "Module Measuring" and "Diagnostic Modules")
If one controller is functional and inserted into the slot at the bottom, the cabinet will work
but the human interface will not be able to present the modules or diagnostic information
modules
8.2 Module Control
The selector allows the Controller unit in service to be chosen. It may be set to position 1, A/R or 2.
When a controller is selected (1 or 2), the DMX A, DMX B and ARTNET signals present at this
controller‟s input are used.
The software configuration is HTP (Highest Take Precedence) by default. It is the highest value of
the DMX A, DMX B and ARTNET inputs (three available universes) and cue played and allocated
to a circuit that is taken into account in order to give the output dimming level.
1