700002 Rev. F
© 2012 ADA EZ. ALL RIGHTS RESERVED.
44 of 56
f.
PRESS and HOLD the “ENTER” pushbutton for three seconds. The operator shall
exit programming mode.
8.4.3
ENABLE or DISABLE Dynamic Braking (factory default is ON):
a.
PRESS and HOLD “SELECT” and “ENTER” for 3 seconds to enter programming
mode. LEDs DS8 through DS11 shall flash green briefly.
b.
WAIT for the “CLS” LED to illuminate.
c.
PRESS and RELEASE the “SELECT” pushbutton to advance until the “PC, PG,
DB, XY” LED
AND
DS10 LED illuminate to set the Dynamic Braking function.
d.
ROTATE the potentiometer to change the state of the LED. The green LED shall
illuminate to indicate that Dynamic Braking function is ON. The red LED shall
illuminate to indicate that the Dynamic Braking function is OFF.
e.
PRESS and RELEASE the “ENTER” pushbutton to store the setting.
f.
PRESS and HOLD the “ENTER” pushbutton for three seconds. The operator shall
exit programming mode
Figure 31. Setting Power Close, Push & Go, and Dynamic Braking
