700002 Rev. F
© 2012 ADA EZ. ALL RIGHTS RESERVED.
17 of 56
CAUTION
To ensure proper installation, the door arm pivot bracket must be fastened to the underside of the header
frame and to the face of the header frame with
at least
three fasteners.
NOTE
When attempting to install the rivnuts to the underside of the door frame it may be necessary to remove the
door stop.
5.3.2
Refer to Figure 10 and, using a center punch, MARK the door arm pivot bracket hole
locations.
5.3.3
If the door frame is aluminum and rivnuts must be installed, PERFORM the following:
a.
Using a
25
/
64
″ drill, DRILL the door arm pivot bracket holes.
b.
Using a rivnut tool, INSTALL the ¼-20 steel rivnuts.
c.
INSTALL and TIGHTEN the three (minimum) ¾″ (19.05 mm) socket head
capscrews securing the door arm pivot bracket to the underside and face of the frame
header.
5.3.4
If the door frame is wood, PERFORM the following:
a.
Using a
5
/
32
″ (3.97 mm) drill, DRILL the door arm pivot bracket pilot holes.
b.
INSTALL and TIGHTEN the three #14 x 1 ¼″ wood screws (minimum) securing
the door arm pivot bracket to the underside and face of the frame header.
Figure 10. Mounting the Door Arm Pivot Bracket