www.acti.com
NVR 2.2 SP3 (V2.2.57) User’s Manual
58
detection area. The motion detection region setup rectangle will show up when this is
enabled.
6.
Sensitivity:
Enter the sensitivity level of this motion detection region. Higher sensitivity
levels are more easily triggered, but may give more false alarms. Sensitivity may range
from 1-100
7.
Name:
Enter the name of this motion detection region. This is the name that will be
shown in Event manager and the Active Monitor event panel when motion activity is
detected.
8.
Timer:
The interval before the next motion detection can be triggered again. The range of
available value is 1-300 seconds.
9.
Description:
Enter more detailed description of this motion detection area. Both the
name and the description will be shown in the event manager.
10.
Enable/Disable PIR Event:
Click this button to enable / disable PIR detection.(Available
only to certain models)
11.
Motion Region:
Click and Drag to setup the location and size of the target motion region
in view window
After you
‟ve completed setup, please click “Apply” to save into to camera and NVR. This
process may take a short while. If you have pressed
“Get motion setting” and leave the page
without applying, the system will provide a warning message to urge you to save all changes.
If you have changed the motion detection settings via the web configurator, please remember
to come back to NVR and press Get device settings, then click apply to save to NVR. This is to
ensure that the settings in NVR are always in sync with the device.
* For ACTi TCM/TCD model devices, motion detection is available when codec is either H.264
or MPEG4. MJPEG does not support motion detection.