www.acti.com
NVR 2.2 SP3 (V2.2.57) User’s Manual
59
PTZ
This section describes how to set the PTZ (Pan/Tilt/Zoom) parameters for this camera. IP PTZ
cameras may be controlled directly. Or you may use a video server to either connect to an
analog PTZ camera or an analog PTZ camera plus a PTZ platform. You need to complete
setup in this section to enable PTZ Preset and Preset Tour sections. If the parameters here are
incorrect, the device will not respond properly to your PTZ commands.
Fig. 32 Camera Setup - PTZ setup
1.
Apply button:
Click this button after you finish setup to save the settings
2.
Enable/Disable PTZ:
Click this to enable or disable the PTZ function of this device.
3.
Vendor:
Select the vendor of the PTZ device/ speed dome you wish to control. You may
select the device type directly if it is listed here.
4.
Protocol:
Select the protocol of the PTZ device/ speed dome.
5.
PTZ File:
If the protocol for your PTZ device is not within the previous list, you can import
a new protocol file to control the PTZ device / speed dome.
Commands in PTZ file will
override the protocol previously selected.
For details about the protocol file format,
please contact our technical support. PTZ file setup is not available for Web Clients.
6.
Address ID:
Enter the address ID of the PTZ device / speed dome.
7.
Parity:
Enter the parity of the PTZ device / speed dome.
8.
User Command List:
If your speed dome or PTZ device has a special function not
supported in the standard protocol. Ex: Activate the wiper to clean the window of the PTZ.
User can manually input the command to activate the wiper for later selection in PTZ
controls.