Gen II
User Manual
22-7 – Analyzer Management
Chapter 22
Revision 2.10, Apr 2020
22.2.1.
– Set Date/Time
The first available setting is that of the date and time. Follow the instructions below to set the
date and time to your specific requirements.
Enter the time in a 24-hour format as follows in the “
Time
” field.
Hour - Valid range is 1 through 24, followed by a “.” (Decimal)
Minute - Valid range is 0 through 59, followed by a “.” (Decimal)
Seconds - Valid range is 0 through 60
Use the [
] to move to the “
Date Format
” field. You may specify the date format you
wish to use by using the [
] key to toggle the selection to the format you wish to use.
Available formats are: MM/DD/YYYY, DD/MM/YYYY and YYYY/MM/DD, where
YYYY = Year, MM = Month and DD = Day.
Use the [
] key to move to the “
Month
” field and enter the month. Valid range is
01 through 12.
Use the [
] key to move to the “
Day
” field and enter the say. Valid range is 01
through 31.
Use the [
] key to move to the “
Year
” field and enter the Year. Valid range is
1998 through 9999. Press [OK] to accept the entries and exit the screen.
The analyzer must know your local time zone. Select the correct geographic location by:
