AccuEnergy Acuvim II, User Manual

Page: 143 / 280

135
3. Set configuration mode in the first setting page. “AUTO” means that users
configure module settings with DHCP protocol while “MANU” means that users
configure module settings with manual setting. Press “V/A” key, to go to the
setting state and the area pointed out in Figure 5-29 will flash. Press “P” key or
“E” key to select configuration mode, press “V/A” key to accept. Press the "P" key
again to go to the second setting page for IP Address.
Note: If you select the “AUTO” mode, please go to step 11 directly and reset
module. Wait until the reset is finished and find the new IP address in the
following step.
Fig 5-29
4. Set IP Address in the second setting page, such as 192.168.1.254 as shown
below. Press the "V/A" key to go to the IP setting page. Users may set the
parameters in the area pointed out in Figure 5-30. The cursor starts at the first
digit. After setting the IP address press the "V/A" key to accept. Press the "P" key
again to go to the third setting page for Subnet Mask.
Shop for Power Metering products online at:
1.877.766.5412
www.
PowerMeterStore
.com