46
Call up a menu by simply pressing the corresponding button. Once you have opened the menu and
it appears in the display, you can scroll through its parameters one after another using the PARAM-
ETER buttons and edit them using the VALUE buttons and knobs.
If you press the PARAMETER buttons briefly, you can scroll through the parameters contained in
any given menu step by step in the desired direction. If you press and hold one of the parameter
buttons for a bit longer, the display will automatically scroll through the list of parameters in the
given menu. When you press and hold one PARAMETER button and then press the other PARAME-
TER button, the display will scroll through the menu in parameter groups in the direction of the but-
ton that you are holding down. This handy feature lets you swiftly go from one parameter type to
another, for instance, from all chorus-related to all delay-related parameters. If you also hold the
second parameter button down, the menus will automatically scroll in the selected direction. Once
you’ve scrolled to the desired parameter group, simply select the desired parameter by pressing the
button briefly. You can also step through the parameters by repeatedly pressing the same menu
button.
The menus, particularly the EFFECTS menu, contain parameter groups that are related by virtue of
their function, for instance, all parameters that are used to control the phaser. When you switch the
phaser off (PHASER Dry/Eff = OFF), all Phaser parameters are of course irrelevant and will no longer
appear in the menu. In other words, when the phaser is disabled, you can’t view its parameters. The
reason for this is to make menus clearer and less cluttered.
The VALUE +/- buttons let you change the value of a parameter in steps. When you hold one of
these buttons down, the value changes automatically and the longer you hold the button, the faster
the pace of the value change. You can increase this pace even further by pressing and holding one
VALUE button and simultaneously pressing the other VALUE button. If you press and release both
VALUE buttons simultaneously, the parameter is set to its default value (mostly zero). This pertains
to unipolar parameters (value range of 0 to 127) as well as bipolar parameters (value range of -64 to
+63).
You can also use the VALUE knob to change the value of the selected parameter. The VALUE knob
responds to the KNOB MODE settings as described in the paragraph below.
The triangular icon located next to the parameter value indicates in which direction you have to
change a value if you would like to reset the parameter to the value that has been stored to date.
The previously stored parameter value as well as the current value are displayed for parameters that
feature a dedicated knob.
Summary of Contents for VIRUS CLASSIC
