30
FIRST-TIME LIGHTING INSTRUCTIONS
Safety Information
•
This fireplace is equipped with an ignition device which automatically lights the pilot. Do not attempt to light pilot by hand.
•
Before operating, smell all around the area for gas. Be sure to smell next to the floor because some gas is heavier than air
and will settle on the floor.
• Toggle master switch to on. The burners will not ignite unless the master switch is on.
• Use only the supplied remote control to light the pilot. This valve will not operate if the pilot is not lit and stable.
•
Do not use if any part has been underwater. Immediately call a qualified service technician to inspect and replace
any component which has been under water. Attempted operation may result in fire or explosion resulting in property
damage, personal injury, and loss of life.
Operating Instructions
1. Read the above safety information carefully before proceeding.
2.
Do not attempt to light the pilot by hand; the door must remain on this fireplace during pilot ignition, except for the first time
lighting.
3. Press the On/Off button on remote control to begin the ignition sequence.
4. There will be an audible beep and then the igniter will begin to spark. After the pilot lights and is established, the valve will
automatically open and the burner will light. The burner will initially light to full flame. Adjust it to an appealing setting with
the remote (see “Remote Operating Instructions” in this manual).
5. Press On/Off button on remote control again to start ignition sequence.
6. If it will not operate, follow the instructions “Turning Off” section and call your service technician or gas supplier.
Turning Off
1. Press the On/Off button on the remote control.
2.
Turn off the external manual shutoff valve supplied by installer and mounted adjacent to the fireplace.
3.
Turn off all electric power to the fireplace if service is to be performed.
If the pilot fails to light, the system will “lockout”. Press On/Off button on remote control to turn off the system. Allow five
minutes for any gas to dissipate before attempting to re-light the pilot.
If you do not follow these instructions exactly, a fire
or explosion may result causing property damage,
personal injury, and loss of life.
WHAT TO DO IF YOU SMELL GAS
•
Do not light any fireplace.
• Do not touch any light switch
• Do not use any phone in your building.
• Call your gas supplier from a neighbor’s phone.
• Follow the provider representative’s instructions.
•
If you cannot reach your gas supplier, call the fire
department for assistance.
HOMEOWNER OPERATION
