40
3. Next place a screwdriver in the track adjustment prying slot shown on the previous page
.
For the
Right side tug track (shown)
pry by pushing the screwdriver towards the front
(loading side).
For the
Left side tug track
pry by pushing the screwdriver towards the back
(non-loading side).
While holding the Rail Support Adjustment in place, tighten one of the 9/16” hex bolts so
the rail remains in place without having to hold it with the screwdriver. Firmly tighten the
other 9/16” hex bolt to 30ft-lbs. followed by tightening the fi rst hex bolt to 30ft.-lbs. Once
the bolts have been the tracks has been adjusted and the tug is ready for use. Do not over
tighten the tracks, they should only be adjusted to allow you to put two fi ngers between
To loosen the track for removal or repair follow these steps.
4. Once the track has been adjusted, tighten the front end retainer bolt.
5. Re-install the outside track cover.
6. Repeat steps 1 thru 5 for the other track.
1. Remove the large outside cover from the side you want to loosen.
2. Use a 7/16” socket to loosen the front end retainer bolt.
3. Next use the socket to slightly rotate the hex track adjuster to relieve tension on
the internal adjuster ratchet mechanism. CW for the left side, CCW for the right side.
Side View of Rail Support Adjustment
Adjustment Side
Motor/Fixed Side
