18
4. Align the center numbered #1 thru hole and one end of the center tube shown and insert the
T-Handle pin (Part #95545) far enough until the handle cannot slide out freely. Remove the
T-Handle Pin on the side with the adjustment handle and leave out until the tug’s width has
been adjusted to the previously measured width. This connection does not adjust and will re-
main intact when adjusting the width of the T1H3 tug. Facing down on the adjustment handle
turn it counter-clockwise until it can no longer turn.
3. Align the thru holes on both the center numbered tube and end of the tube shown and insert
T-Handle pin (Part #95545) far enough until the handle cannot slide out freely. Take note this
pin will be removed and adjusted in step 6 of this process when connecting both the right and
left tugs.
#1 Thru Hole
Figure 1
Figure 2
Figure 3
Center Tube
