46
wireless siren module (see section 7.3.4).
Note: Instead of training the accessory module to the wireless
alarm system, it is trained to the second accessory module.
Only then program the second accessory module connected to the
alarm system. Do this as follows:
1. In the main programming menu, select item 7 (Function). LED
7 lights up.
Confirm by pressing SET.
In the submenu of item 7 (Function), select function 5 with the
SELECT button. LED 5 lights up.
Confirm by pressing SET.
LED 7 lights up again.
2. In the main menu of the accessory module, select item 1 (Train
detector). LED 1 lights up.
Trigger the tamper contact on the accessory module that works
as a wireless siren module and is connected to the siren.
When the accessory module working as a wireless siren
transmitter/receiver has received the signal, the blue LEDs 1-3
flash on the module.
Exit the programming mode by pressing ESC/DEL.
The LED for the power supply lights up/flashes and the fault
LED lights up. The accessory module beeps at short intervals.
Close both tamper contacts of the WAM and wait until it emits
a double tone.
The accessory module is now trained as a wireless siren
transmitter/receiver. When the input 1 (2) is closed, output 1
(2) on the other accessory module (connected with the siren) is
activated.
3. Connect the accessory module with the alarm centre as
illustrated.
TR is the sabotage input of the alarm centre.
On the alarm system, program output 1 to after a
siren (NO) and output
2 to after a flash (NO).
