7.2 Control system
Fig. 7.6
Fig 7.7
The control box is attached to the underside of the machine table by means of the four enclosed screws.
The mains connection is single-phase, using the three-wire cord protruding from the rear and a standard
safety plug.
The control system has peripheral functions:
on the front panel (Fig. 7.6):
X0
nine-pole D-sub jack for data transfer
on the rear panel (Fig. 7.7):
sockets or connector plugs
X1
quadripole socket for connecting the motor’s stator coil
X2
nine-pole D-sub jack for connecting the motor’s increment encoder
X3
nine-pole D-sub plug for connecting set point adjuster SWG2 (Art. No. 63.012)
X4
nine-pole D-sub plug for connecting the control panel OC-TOP/AP (Art. No. 64.175)
X5
37-pole D-sub jack for connecting the process control system (keys, switches, solenoids,
solenoid valves) on the machine.
X6
six-pole RJ45 western jack for connecting from a light barrier
X7
six-pole RJ45 western jack for connecting from a bobbin thread supply monitor
In function, the control is connected with the sewing machine/sewing unit via:
Inputs (Ex), e.g. for push-buttons, switches, proximity switches, detectors, and
Outputs (Ax), e.g. for solenoids, solenoid valves, signal indicators.
p-40-ed-2-en
7.2
04-03-08
X0
