Chapter 3
3-30
Note:
If you specific the IRQ in this item, then you cannot specific the same IRQ to Legacy
ISA. Otherwise, it will cause the hardware conflict.
You must familiar with the PCI interrupt distribution mechanism to adjust this
setting. This feature is for the OS who will record and fix the PCI
configuration status, and you want to change it.
For the relations between the hardware layout of PIRQ (the signals from the
PIIX4 chipset), INT# (means PCI slot IRQ signals) and devices, please refer
to the table below:
Signals
PCI slot 1
AGP slot
PCI slot 2
PCI slot 3
PCI slot 4
PCI slot 5
PIRQ_1
INT A
INT B
INT C
INT D
PIRQ_2
INT B
INT C
INT D
INT A
PIRQ_3
INT C
INT D
INT A
INT B
PIRQ_4
INT D
INT A
INT B
INT C
l
USB used PIRQ_4.
l
Each PCI slot has four INT#s (INT A~INT D), and the AGP slot has two
INT# (INTA and INT B).
Summary of Contents for BX6
