EN
-
16
6 Putting into operation
ABICAR 1200 PRO
6.5.2 Configuration menu
Up to 40 welding programmes (JOBs) can be created and saved in the configuration menu.
Accessing the configuration menu
Navigating the configuration menu
You can navigate as follows in the configuration menu:
Saving the JOB.
1
Set all parameters.
2
Rotate F1 to change to the “Save setup” parameter.
3
Rotate F2 to select the desired JOB number.
4
Press F2.
The JOB will be saved and the message “Done” will be shown briefly on the display.
Changing the JOB
1
Rotate F1 to change to the “Load setup” parameter.
2
Rotate F2 to select the desired JOB number.
3
Press F2.
The configurations saved in the JOB will be loaded and the message “Done” will be shown briefly on the
display.
The configuration can now be adjusted and re-saved.
► To enter the configuration menu, keep F1 pressed for
approx. 3 s.
It is changed in the configuration menu and the
“Carriage speed” parameter will be displayed.
► To re-enter the configuration menu, keep F1 pressed
for approx. 3 s.
Tab. 4
Menu navigation
Required actions
Function
Rotate F1 to the right or to the left.
Select the next or previous parameter.
Tab. 5 Welding parameters overview auf
Seite EN
Rotate F2 to the right or to the left.
Set the value of the selected parameter.
The value will be applied and does not have to be
confirmed.
Keep F2 pressed and rotate to the right
or to the left.
Set the units position or the decimal place of the
selected parameter.
The value will be applied and does not have to be
confirmed.
Press F2.
Confirm and save the selection.
(Only for “Save setup” and “Load setup”.)
