ABC Design Mamba 6970, Instructions For Use Manual

Page: 6 / 31

EN - 09
6 6
7
8 8
9
10
11
6. Fitting and removing the guard rail
Fit the guard rail by inserting it in the plastic mounts on both sides.
To remove the guard rail from the pushchair, press in the buttons on
both sides and pull the guard rail off away from the pushchair.
7. Adjusting the leg rest
To adjust the leg rest, press in the buttons on both sides and then
adjust the height.
Let go of the buttons again so that the leg rest clicks into place.
8. Fastening the harness
To fasten the harness, bring the top two plastic catches together and
interlock them.
Then insert the interlocked catches into the bottom part of the
fastening.
Adjust the harness to a setting where the baby is held in the correct
position.
9. Unfastening the harness
To open the harness, press the button on the side.
CAUTION: Always use the shoulder harness and lap belt together.
10. Adjusting the backrest
To adjust the seat unit, pull the retainer on the rear of the backrest
upwards and then adjust the height of the seat. When you have
reached the required position, let go of the retainer to allow the seat
to remain in that position.
11. Adjusting the handle
Push the button upwards to adjust the height of the handle.
When the handle is at the required height, let go of the button again
so that the handle will remain locked in this position.
EN - 10
12
13
14 14
14
15
12. Folding the pushchair
To fold the pushchair, bring the handle to its lowest position as
described in point 19, holding the button (1) down as you do so.
Now rotate the knob (2) to the left and push the handle down.
Now you can fold up the pushchair.
Note: To unfold the pushchair, follow the instructions in point 1
“Opening the pushchair”.
CAUTION: Ensure that all the catches are engaged before use.
Carrycot
13. Opening the carrycot
Lift the side panels of the carrier.
Extend and secure the side panels by pushing the two retainers
outwards into the mountings.
Make sure that the retainers are securely engaged.
14. Attaching the cot bumper
Lay the bumper in the cot, folding the top part over the edge of the
carrycot.
Fasten the press studs and close the Velcro fastenings on the sides.
15. Attaching the hood to the cot bumper
Fasten the press studs on the bottom of the hood onto the bumper.