ABB IRB 4600 Foundry Prime, Product Manual

Page: 103 / 408

Protecting the wrist joints
The sealings between the moving parts on the wrist must not be exposed to direct
high-pressure water. We recommend that the gripper include a shield that prevents
direct water flush on the sealing surfaces of the wrist. The sealings are pointed
out in the illustration below.
A
B
C
xx0600003108
Axis 5, bearing support side A
Axis 5, bearing gear side B
Axis 6, mounting flange - gear house C
Protecting the wrist flange from corrosion
The mounting surface on the wrist flange is protected with grease. The joint between
the wrist flange and the tool and the screw holes on the wrist flange must be
protected.
Note/Illustration Action
A
B
xx0600003109
After mounting the tool, clean the following
surfaces from grease:
• the visible surface (not painted)
• the rear end of the screw holes and
end of screws.
1
A screw holes and screws
B unpainted surface
Protect these surfaces with Mercasol. 2
Continues on next page
Product manual - IRB 4600 Foundry Prime 103
3HAC040585-001 Revision: M
© Copyright 2013-2018 ABB. All rights reserved.
2 Installation and commissioning
2.10.1 Installation of IRB 4600 Foundry Prime in a water jet application
Continued