Elimination/Action
Description
Warning
Make sure that protective gear
like goggles and gloves are al-
ways worn.
When working with lubricants
there is a risk of an allergic reac-
tion.
Allergic reaction
Open the plug carefully and keep
away from the opening. Do not
overfill the gearbox when filling.
When opening the oil or grease
plug, there may be pressure
present in the gearbox, causing
lubricant to spray from the
opening.
Possible pressure
build-up in gearbox
Make sure not to overfill the
gearbox when filling it with oil or
grease.
Overfilling of gearbox lubricant
can lead to internal over-pres-
sure inside the gearbox which in
turn may:
•
damage seals and gas-
kets
•
completely press out
seals and gaskets
•
prevent the robot from
moving freely.
Do not overfill
After filling, verify that the level
is correct.
When filling gearbox oil, do not
mix different types of oil unless
specified in the instructions. Al-
ways use the type of oil specified
for the product.
Mixing types of oil may cause
severe damage to the gearbox.
Do not mix types of oil
Run the robot before changing
the gearbox oil, if possible.
Warm oil drains quicker than
cold oil.
Heat up the oil
After filling, verify that the level
is correct.
The specified amount of oil or
grease is based on the total
volume of the gearbox. When
changing the lubricant, the
amount refilled may differ from
the specified amount, depending
on how much has previously
been drained from the gearbox.
Specified amount de-
pends on drained
volume
For lifetime reasons always drain
as much oil as possible from the
gearbox. The magnetic oil plugs
will gather residual metal chips.
Contaminated oil in
gearboxes
Hazards related to batteries
Under rated conditions, the electrode materials and liquid electrolyte in the batteries
are sealed and not exposed to the outside.
Continues on next page
Product manual - IRB 360
35
3HAC030005-001 Revision: Z
© Copyright 2008-2021 ABB. All rights reserved.
1 Safety
1.6.1 Maintenance and repair
Continued
Summary of Contents for IRB 360
