ABB CONCEPTPOWER CLASSIC DPA-50, User Manual

Page: 55 / 113

Section-4
04-3008_S4_ABB_OPMCPDPA-S2_GB_121202 Page 5/10 ABB
Printed in Switzerland – Modifications reserved
4.1.3 Description of the LCD
4.1.3.1 Status Screens
DESCRIPTION LCD-DISPLAY
1
Load is protected by UPS power.
Load is supplied by inverter (Normal Operation)
and the batteries are connected and o.k.
LOAD
PROTECTED S
2 Load is not protected by UPS power.
Load is supplied by mains power (load on
bypass) or it is supplied by the inverter (Normal
operation) and the batteries are not o.k. LOAD
NOT PROTECTED P01
3 Load not supplied.
UPS is switched off
To start the UPS press the two ON/OFF push
buttons simultaneously LOAD OFF
SUPPLY FAILURE P09
4 The UPS is not supplying load anymore. The
output switch is open LOAD DISCONNECTED
PARALLEL SWITCH OPEN P20
NOTE: On the right hand side of the LCD there is the indication of single /parallel UPS.
If the UPS is configured as single the indication will be “S”
If the UPS is configured as parallel the indication will be “P” followed by the UPS number
The max no. of module units are 20 per system.
EXEMPLES:
S stands for Single UPS. The system consists of ONLY one UPS (e.g. Classic cabinet)
P01 stands for Parallel UPS in a Multi-UPS system and 01 stands for the first Module (MASTER)
in the Multi-UPS system.
P09 stands for Parallel UPS in a Multi-UPS system and 09 stands for the ninth Module (SLAVE)
in the Multi- UPS system.
P20 stands for Parallel UPS in a Multi-UPS system and 20 stands for the twentieth Module (SLAVE)
in the Multi- UPS system.
The configuration of the single / parallel UPS is achieved in the Menu “SET UP SERVICE”. See Service Manual
section E.
4.1.3.2 Main Menu Screen
DESCRIPTION LCD-DISPLAY
1 Logging Control. A log of the last 64 events is
stored in the Power Management Display.

EVENT LOG
MEASUREMENTS
2 In Menu Measurements: monitor voltages,
power,frequencies, currents, autonomy etc.

MEASUREMENTS
COMMANDS
3
The Command Menu enables to perform the
commands “Load to inverter”, Load to bypass,
battery test.

COMMANDS
UPS DATA
4
The UPS Data are the UPS personalized
information “serial number”

UPS DATA
SET-UP USER
5 Various settings can be performed by the user:
Date/Time, automatic battery test, etc.

SET-UP USER
SET-UP SERVICE
6 Various adjustments can be performed by the
service staff

SET-UP SERVICE
NO MORE MENU