ABB ACS880-04F-504A-3, Hardware Manual

Page: 109 / 202

Connector pitch 5 mm, wire size 0.5 … 2.5 mm
2
(22…12 AWG) Analog outputs AO1 and AO2 (XAO)
0…20 mA, R
load
< 500 ohm
Frequency range: 0…300 Hz
Resolution: 11 bit + sign bit
Inaccuracy: 2% of full scale range
Connector pitch 5 mm, wire size 0.5 … 2.5 mm
2
(22…12 AWG) XD2D connector
Physical layer: RS-485
Transmission rate: 8 Mbit/s
Cable type: Shielded twisted-pair cable with a twisted pair for
data and a wire or another pair for signal ground (nominal im-
pedance 100 … 165 ohm, for example Belden 9842)
Maximum length of link: 50 m (164 ft)
Termination by jumper
Connector pitch 5 mm, wire size 0.5 … 2.5 mm
2
(22…12 AWG) Safe torque off connection (XSTO)
Input voltage range: -3…30 V DC
Logic levels: "0" < 5 V, "1" > 17 V.
Note: For the unit to start, both connections must be “1”. This
applies to all control units (including drive, inverter, supply, brake,
DC/DC converter etc. control units), but true Safe torque off
functionality is only achieved through the XSTO connector of
the drive/inverter control unit.
Current consumption: 66 mA (continuous) per STO channel
EMC (immunity) according to IEC 61326-3-1 and IEC 61800-5-2
Connector: RJ-45 Control panel connection (X13)
Cable length < 100 m (328 ft)
The terminals of the control unit fulfill the Protective Extra Low Voltage (PELV) requirements. The PELV
requirements of a relay output are not fulfilled if a voltage higher than 48 V is connected to the relay
output.
Control unit of the drive 109