ABB ACS 600 MultiDrive, Hardware Manual

Page: 53 / 94

Appendix A – ACS/ACC/ACP 604/607 Technical Data
ACS/ACC/ACP 604/607 Frequency Converters A-9
External Control
Connection Diagrams
External control connections of ACS 600 equipped with Standard
Application Program (Factory Macro) are shown below. External
control connections are different with other application macros and
programs (see
Firmware Manual).
External control wiring is connected either directly to terminals on the
NIOC board or through an optional terminal block. If an optional I/O
terminal block is furnished, the control panel code (16th digit) of the
ACS 600 type code will contain a 4 or 5. Refer to Chapter 2 for the
ACS 600 type code description.
An optional terminal block can be designated X2 (IEC standard
designation) or 2TB (ANSI standard designation, for US manufactured
units only). The 2TB arrangement is supplied in drives with 8 as the
20th digit of the ACS 600 type code.
When making the external control connections be sure to carefully
compare the terminal configuration found in the drive with diagrams
below to be sure that the correct diagram is used.
External control wiring of ACP 600 is connected either to terminals on
the NIOC board or the NIOCP board. External control connections to
NIOCP board are shown below.