ABB ACS 600 MultiDrive, Hardware Manual

Page: 23 / 94

ACS/ACC/ACP 607 Frequency Converters 2-1
Chapter 2 – Mechanical Installation
See Appendix A – Technical Data for allowed operation conditions of
the ACx 604/607. For installation of ACx 604 module in a cabinet refer
to a supplement to this manual:
Converter Module Installation in User-
defined Cabinet.
The ACx 607 should be installed in an upright vertical position.
The floor that the unit is installed on should be of non-flammable
material, as smooth as possible, and strong enough to support the
weight of the unit. The maximum allowed deviation from the surface
level must be < 2 mm measured every 1 m. The installation site should
be levelled (when needed), as the ACx 607 is not equipped with
adjustable feet.
The ACx 607 can be installed on elevated floor and over a cable duct.
The integrity of the supporting structure must be checked before the
ACx 607 is placed in such a position.
ACx 607 can be installed with its back against a wall. Sufficient room
around the ACx 607 is required to enable cooling air flow, service and
maintenance.
The wall behind the unit should be of non-flammable material.
Installation Procedure
ACx 607
It is advisable to secure the cabinet to the floor with bolts through the
holes at its base or with fastening hooks attached to its bottom front
and back edges. This is especially important in installations subjected
to vibration or other movement.
1. Check the intended installation site for sufficient room. Check that
there is nothing on the floor to inhibit installation. See Appendix B –
ACx 607 Dimensional Drawings and Figure 2-1 for cabinet details.
Mark the locations for the holes (and the cable duct opening).
2 Make holes according to the dimensional drawings. Smooth cable
duct edges if required. Insert plugs into the fastening holes.
3. Place the frequency converter carefully onto the holes.
4. Place bolts in the plugs.
5. Tighten the bolts.